Calculation Of Allowable Load Of Profile | Aluminium Profiles

Calculation conditions concentrated load on the center of a profile that is supported at both its ends.
The allowable load values are calculated assuming 1/1000 of the profile length as the amount of deflect. It is the maximum load in actual applications. For actual application, keep the load within the allowable load range.
For applications which request smaller deflection than in the table, change length (L) shorter or change to a bigger size profile.

Profile Size (mm)	Height X Width (mm)	Section Modulus (cm³)	Moment of Inertia (cm⁴)	Profile Length: L-500mm		Profile Length: L-1000mm		Profile Length: L-2000mm
				(deflection = 0.5mm)		(deflection = 1mm)		(deflection = 2mm)
				Allowable Load		Allowable Load		Allowable Load
				N	Kgf	N	Kgf	N	Kgf
PS2020-6	20x20	0.71	0.71	94	10	21	2	Not applicable	Not applicable
PS2040-6	20x40	1.2	1.2	159	16	35	4	Not applicable	Not applicable
PS2040-6	40x20	2.2	4.5	602	61	146	15	28	3
PS3030-8	30x30	2.2	3.3	440	45	105	11	16	2
PS3060-8	30x60	4.1	6.1	500	51	193	20	28	3
PS3060-8	60x30	7.8	23.3	3125	319	771	79	173	18
PS4040L-8	40x40	4.1	8.2	1097	112	266	27	50	5
PS4040-8	40x40	4.9	9.9	1324	135	321	33	60	6
PS4080L-8	40x80	8.5	17	2276	232	554	57	110	11
PS4080L-8	80x40	15.3	61.2	8217	838	2040	208	481	49
PS4080-8	40x80	9.5	19.1	2556	261	621	63	120	12
PS4080-8	80x40	18.4	73.7	9895	1010	2456	251	578	59
PS8080-8	80x80	34.3	137.2	18423	1880	4577	467	1086	111
PS4545L-10	45x45	4.6	10.4	1393	142	340	35	68	7
PS4545-10	45x45	6.3	14.3	1915	195	466	48	93	9
PS4590L-10	45x90	9.8	22.1	2961	302	725	74	150	15
PS4590L-10	90x45	20.6	92.6	12436	1269	3094	316	743	76
PS4590-10	45x90	12.9	29.1	3895	398	953	97	195	20
PS4590-10	90x45	24.6	110.9	14892	1520	3701	378	882	90
PS4560-10	45x60	7.3	16.6	2223	227	542	55	108	11
PS4560-10	60x45	9.8	29.6	3970	405	978	100	217	22
PS6060-10	60x60	15.9	47.7	6398	653	1578	161	352	36
PS9090-10	90x90	44.1	198.6	26672	2722	6635	677	1592	162